[snappyHexMesh] SnappyHexMesh layer addition iteration

jazbin_hyper · January 18, 2018, 10:21

Hello

Which parameter in snappyHexMeshdict controls the number of layer addition iterations? I would like to set the numbers of iterations to 1, because i'm only interested in 100% layer coverage and if the layers are not grown in first iterations, then the coverage is always smaller.

Thanks

Bojan

Tobi · January 22, 2018, 18:11

It should be the nRelaxIter parameter in the layer subdict. I am not sure right now. However, the numerical cells could be everything else than good, but I guess you know that.

January 22, 2018, 18:11		#2
Tobi Super Moderator Tobias Holzmann Join Date: Oct 2010 Location: Tussenhausen Posts: 2,708 Blog Entries: 6 Rep Power: 51	It should be the nRelaxIter parameter in the layer subdict. I am not sure right now. However, the numerical cells could be everything else than good, but I guess you know that. __________________ Keep foaming, Tobias Holzmann

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
y+ = 1 boundary layer mesh with snappyHexMesh	Arzed23	OpenFOAM Running, Solving & CFD	6	November 23, 2022 15:15
[snappyHexMesh] SHM Layer Addition Phase	dickcruz	OpenFOAM Meshing & Mesh Conversion	4	November 1, 2018 07:05
[snappyHexMesh] snappyHexMesh Boundary Layer at Corner	panpanzhong	OpenFOAM Meshing & Mesh Conversion	5	July 3, 2018 05:53
[snappyHexMesh] snappyHexMesh Parallel bad size error	andrewpomeroy	OpenFOAM Meshing & Mesh Conversion	2	April 2, 2018 01:08
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38