|
[Sponsors] |
[snappyHexMesh] SnappyHexMesh snapping on stlfile fails |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 29, 2008, 10:12 |
SnappyHexMesh snapping on stlfile fails
|
#1 |
New Member
Julius
Join Date: Mar 2009
Posts: 27
Rep Power: 17 |
Hello together,
I'm trying to generate a mesh with snappyHexMesh on a simple ship shape. I already did the example with the igloo and one simple example with a *.stl - ball in the middle of block. Snapping worked fine only the boundary layer not. Now I'm importing a simple hull as a stl-file. Refining works good but it does not snap properly. The only difference to the other examples is that I used distance in "refinementSurfaces" toolbox. I attached the foto of before and after "snapping", the snappyHexMeshDict and the wigley.stl. snappyHexMeshDict wigleyHalf.stl.tar.gz Hopefully someone of you can help me with this because I'm already quite desesperated... Thanks in advance, Regards, Julius |
|
February 19, 2009, 09:05 |
try to turn up the values of
|
#2 |
Senior Member
Wolfgang Heydlauff
Join Date: Mar 2009
Location: Germany
Posts: 136
Rep Power: 21 |
try to turn up the values of
"nSmoothPatch" "nSolveIter" "nRelaxIter" and turn down "tolerance" under "snapControls" { |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh with local refinement of ONE STLfile | wolle1982 | OpenFOAM Meshing & Mesh Conversion | 31 | May 14, 2020 10:57 |
[snappyHexMesh] snappyHexMesh not snapping to cylinder end | wildfire230 | OpenFOAM Meshing & Mesh Conversion | 0 | March 1, 2019 12:09 |
[snappyHexMesh] snappyHexMesh inclinced surface snapping problem | Swift | OpenFOAM Meshing & Mesh Conversion | 19 | January 18, 2017 04:42 |
[snappyHexMesh] SnappyHexMesh : snapping not matching surface | Awak | OpenFOAM Meshing & Mesh Conversion | 4 | May 31, 2016 08:23 |
[snappyHexMesh] SnappyHexMesh - snapping the wrong elements | A.Wendy | OpenFOAM Meshing & Mesh Conversion | 1 | September 25, 2012 03:52 |