 |
 |
 |
|
|
|
[Sponsors] | ||||
September 2, 2009, 15:28
|
how to create faceZones?
|
#1 |
|
Senior Member
Pei-Ying Hsieh
Join Date: Mar 2009
Posts: 334
Rep Power: 18  |
Hi,
Is it possible to create faceZones out of a box, say (-1 -1 -1)(1 1 1)? Or, is it possible to convert a faceSet (which I created using setSet, then, faceSet) to faceZones? (the faceSet in under polyMesh/sets) Thanks! Pei |
|
|
|
|
|
September 2, 2009, 21:26
|
|
#2 |
|
Senior Member
Pei-Ying Hsieh
Join Date: Mar 2009
Posts: 334
Rep Power: 18 |
Hi,
I found that, if there is only one fluid domain, then, setsToZones can convert faceSets to faceZones. But, I am working on a multiRegion case. It looks like setsToZones cannot handle regions. Any suggestion will be appreciated. Pei |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| create the file *.foam | phongstar | OpenFOAM | 12 | October 14, 2018 18:06 |
| [snappyHexMesh] SHM doesn't create cellZones for one region | Eko | OpenFOAM Meshing & Mesh Conversion | 10 | January 24, 2018 02:03 |
| OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 06:47 |
| [GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
| [DesignModeler] Design Modeller create surface | papis | ANSYS Meshing & Geometry | 0 | October 31, 2013 13:52 |
Linear Mode
