 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] Absolute Beginner: How to set-up geometry of circular cylinder |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 19, 2012, 17:35
|
Absolute Beginner: How to set-up geometry of circular cylinder
|
#1 |
|
New Member
Adam Preece
Join Date: Jun 2012
Location: Oxfordshire, UK
Posts: 2
Rep Power: 0  |
Hi all,
I'm an absolute beginner and although the tutorials seem to make sense, how can I set up a geometry for circular cylinder flow? The main problem I can't get my head round is how to cut cylinder into the block faces at either end. Help! Thanks, Dr. P. |
|
|
|
|
|
June 20, 2012, 02:42
|
|
#2 |
|
Disabled
Join Date: Mar 2011
Posts: 174
Rep Power: 15 |
||
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Circular cylinder surface shear stress | Hqjen | STAR-CCM+ | 0 | April 21, 2016 11:13 |
| OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
| Solver and geometry choose for drag coefficient calculation around circular cylinder at large Re | lin | OpenFOAM Running, Solving & CFD | 3 | April 16, 2009 10:50 |
| Env variable not set | gruber2 | OpenFOAM Installation | 5 | December 30, 2005 04:27 |
| How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 10:15 |
Linear Mode
