|
[Sponsors] |
[Other] How to create zero thickness internal walls in a given mesh in OpenFOAM? |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
notyet
Join Date: Jun 2012
Posts: 9
Rep Power: 15 ![]() |
I know using topoSet and subsetMesh along the lines of the mesh/moveDynamicMesh/simpleHarmonicMotion tutorial, one can cut holes into a mesh and obtain new patches. How can something similar be achieved with a vanishing hole, i.e. can a set of internal faces be turned into two touching patches with opposite orientation?
-- also posted at http://scicomp.stackexchange.com/q/2715/1669 |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
notyet
Join Date: Jun 2012
Posts: 9
Rep Power: 15 ![]() |
As gschaider posted at SE, I simply need to use the createBaffles tools
|
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Internal Walls in mesh | Rakkiran | OpenFOAM Meshing & Mesh Conversion | 6 | April 15, 2021 02:48 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
OpenFOAM v3.0+ ?? | SBusch | OpenFOAM | 22 | December 26, 2016 14:24 |
Create thickness for zero thickness surface mesh | zonexo | Mesh Generation & Pre-Processing | 0 | May 28, 2016 11:35 |
[Commercial meshers] Fluent Mesh to OpenFoam: Internal Surface has to be a wall | sebastian | OpenFOAM Meshing & Mesh Conversion | 6 | October 21, 2010 04:36 |