[Other] [OpenFOAM] Non-conforming mesh and GGI -- CFD Online Discussion Forums

July 26, 2012, 02:25	[OpenFOAM] Non-conforming mesh and GGI	#1
m_f Member M Join Date: Jul 2012 Posts: 33 Rep Power: 13	Hello, Can we define a non-conformal mesh in OpenFOAM ? I have two fluids, and i want to calcul a heat transfer between these two fluides. But i want to mesh one of them in hexa, and the other in treta, without common nodes. Can I use General Grid interface algorithm ? Excuse for my english. Thank you for any hint, Best regards m_f. Last edited by m_f; July 26, 2012 at 03:01.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Create a GeometricField of a given type on given patch?	philippose	OpenFOAM Programming & Development	4	August 12, 2013 12:41
[snappyHexMesh] SNappyHexMEsh and GGI (standing mesh gets deleted)	A.Wendy	OpenFOAM Meshing & Mesh Conversion	1	August 2, 2013 07:04
GGI for volumes / mesh mapping?	orca.blu	OpenFOAM Programming & Development	2	September 28, 2012 10:02
GGI in OpenFOAM-1.5-dev	philippose	OpenFOAM Running, Solving & CFD	14	November 13, 2011 14:55

All times are GMT -4. The time now is 02:24.