layers on snappyhexmesh
1 Attachment(s)
I've a problem with snappyhexmesh :(
I've enabled layers creation, but with no changes on mesh... necessary i've done some mistakes... but i'm not able to find where they are any idea? Thanks |
I have only used snappyhexmesh for one mesh but I know that I had problems with the layers forming when I set nGrow to anything other than 0 but that's not the problem in this case since yours is already at 0. I would play with the feature angle. If you set it to 180 then layers should grow no matter what the angle. If this doesn't do anything then I would try increasing your tolerance's. What type of geometry are you meshing?
|
Ok :D now with ngrow 0 and feature angle 180 it works well :cool:
thank you |
All times are GMT -4. The time now is 05:46. |