 |
 |
 |
|
|
|
[Sponsors] | ||||
September 30, 2012, 08:33
|
converting interfaces to ami
|
#1 |
|
Member
Hossein
Join Date: Apr 2010
Posts: 65
Rep Power: 16   |
Dears,
Can I convert a gambit mesh to OF2.1.x and then change the interface boundaries that defined in gambit to the ami bounadries in the boundary dictionary. I want to use it for dynamic mesh in OF. Best Regard, Hossein |
|
|
|
|
|
March 9, 2013, 19:16
|
|
#2 | |
|
Senior Member
Join Date: Nov 2012
Posts: 171
Rep Power: 13 |
Hi Hossein,
Have you solved that problem you mentioned in the thread? I have the same problem. I generated the mesh for multiply bodies (multiply bodies) using ICEM. The interfaces between neighboring bodies have non matched grid nodes. So I would like to use AMI but the interface itself does not move during the simulations. Do you know how to convert the interface into AMI in openfoam? best regards, H Quote:
|
||
|
|
|
||
|
April 24, 2013, 05:15
|
|
#3 |
|
Member
Andreas Wendy
Join Date: Aug 2012
Posts: 73
Rep Power: 13 |
never used a gambit mesh before but can't you just modify the boundary file in contant/polymesh and the U,p, etc files in the 0 folder in a text editor?
maybe you can upload these files and i can try? Andreas |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mapField error | rvl565 | OpenFOAM Pre-Processing | 1 | September 6, 2018 16:13 |
| Translating and Rotating AMI | HiddenSquid | OpenFOAM Pre-Processing | 1 | October 25, 2017 03:59 |
| AMI Motions: Ramped Rotation Speeds and Nested Sliding Interfaces | lordvon | OpenFOAM Programming & Development | 0 | September 24, 2013 01:30 |
| dynamic Mesh is faster than MRF???? | sharonyue | OpenFOAM Running, Solving & CFD | 14 | August 26, 2013 07:47 |
| mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |
Linear Mode
