Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[Other] sprayfoam error after some time steps

Mark Forums Read

Reply

Search this Thread

May 21, 2013, 06:21	sprayfoam error after some time steps	#1
azborals New Member André Zboralski Join Date: Jan 2013 Posts: 11 Rep Power: 14	hallo everyone, i tried to run a complex case by sprayFoam. it is an intake port bei an gasoline engine withe valves and cylinder, but there is no movement. i want to get ssteady flowfield and then i want to start the injection. but after some time steps the case stopped because of very a very high velocity and temperatur in a cell near the inlet. can i repair or delete the cell. thank you!

Reply

Tags

flowfield, sprayfoam

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
courant number increases to rather large values	6863523	OpenFOAM Running, Solving & CFD	22	July 6, 2023 00:48
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field	lakeat	OpenFOAM Community Contributions	58	December 23, 2021 03:36
LES, Courant Number, Crash, Sudden	Alhasan	OpenFOAM Running, Solving & CFD	5	November 22, 2019 03:05
pimpleDyMFoam computation randomly stops	babapeti	OpenFOAM Running, Solving & CFD	5	January 24, 2018 06:28
Star cd es-ice solver error	ernarasimman	STAR-CD	2	September 12, 2014 01:01

All times are GMT -4. The time now is 20:37.