SnappyHexMesh -- Giving Up -- Reason
Hello
I am trying to mesh the geometry of a centrifugal blower. I am having trouble with snappy saying that it "cannot sap successfully .. Giving up". I could not figure out what is happening. I read a lot of discussion about this problem in the thread .... PHP Code:
Also in the snappy hex mesh log I found that the given point is found in cell number -1 of the region 0 of 4 ... Is it a problem I meant ... -1 cell ...?? But this is not the case in the beginning ... !! this cell number was a positive number in the beginning .. !! later it is -1 ... !! Thanks in advance. |
All times are GMT -4. The time now is 21:43. |