[snappyHexMesh] Sharp edges not being refined properly

ebaldwin · September 10, 2013, 14:16

Hello,

I'm new to snappyHexMesh and I've read through the snappy user guide as well as all relevant cfd-online posts. I am trying to make a mesh for a two nozzle impinging spray. The mesh will include one of the nozzles and a symmetric boundary on the plane where the jets collide. There is a second symmetric plane through the nozzle to minimize cell count. For now I am working with a single refinement cylinder of level 4 around the nozzle.

I am using explicit edge / feature snapping with surfaceFeatureExtract. The two primary problems that I am observing are,
1. Rounding of some sharp edges
2. Disruption of the symmetric plane

Attached are some screenshots of the current mesh snappyHexMesh is generating. There is a refinement cylinder with a refinement level of 4 around the nozzle. The snappyHexMeshDict is also attached. Any help is welcome!

Thanks,
Eli

Artur · September 11, 2013, 05:28

I must say that edge problem looks like nothing I've seen before. Have you tried previewing the extracted feature lines and checking that they are correct?

(use

Code:

surfaceFeatureConvert constant/triSurface/ImpingingJet0.eMesh ImpingingJet0.obj

and open the .obj file in paraview).

ebaldwin · September 11, 2013, 09:59

Yes, the extracted lines look to be right on.

Artur · September 11, 2013, 10:07

Hmmm.. Any chance of you uploading your geometry then?

September 11, 2013, 05:28		#2
Artur Senior Member Artur Join Date: May 2013 Location: Southampton, UK Posts: 372 Rep Power: 19	I must say that edge problem looks like nothing I've seen before. Have you tried previewing the extracted feature lines and checking that they are correct? (use Code: surfaceFeatureConvert constant/triSurface/ImpingingJet0.eMesh ImpingingJet0.obj and open the .obj file in paraview).

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] snappyHexMesh sticking point	natty_king	OpenFOAM Meshing & Mesh Conversion	11	February 20, 2024 09:12
[cfMesh] layer addiction on sharp edges	student666	OpenFOAM Community Contributions	1	October 27, 2020 18:22
[snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell	Arman_N	OpenFOAM Meshing & Mesh Conversion	1	May 20, 2019 17:16
[snappyHexMesh] sHM layer process keeps getting killed	MBttR	OpenFOAM Meshing & Mesh Conversion	4	August 15, 2016 03:21
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11

September 11, 2013, 09:59		#3
ebaldwin New Member Eli Baldwin Join Date: Aug 2013 Posts: 9 Rep Power: 12	Yes, the extracted lines look to be right on.

September 11, 2013, 10:07		#4
Artur Senior Member Artur Join Date: May 2013 Location: Southampton, UK Posts: 372 Rep Power: 19	Hmmm.. Any chance of you uploading your geometry then?