 |
 |
 |
|
|
|
[Sponsors] | ||||
October 22, 2013, 12:18
|
error in msh file
|
#1 |
|
New Member
Akihiro Tamaru
Join Date: Oct 2013
Location: Japan
Posts: 3
Rep Power: 14   |
Hi there,
I deal with a hard disk drive model meshing for LES. I’m having a trouble with writing out fluent mesh(.msh) file. In the file, I found a lot of #IND characters. I checked blockings and other parameters but cannot find good ways.Is there any solutions? Thanks. Akihiro |
|
|
|
|
 |
| Tags |
| icem, icem 3d, meshing 3d |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 07:47 |
| centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 02:41 |
| [OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 04:23 |
| "parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 12:44 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 18:51 |
Linear Mode
