blockMesh | MergePatchPairs | snappyHexMesh |Different number of cells in divisions
Hi there,
i have a question concerning blockMesh, especcially the mergePatchPair-section. I would like to create 2 blocks (block I and block II) as you can see in the image below. One can see, that these blocks should have different numbers of cells in the y-direction. If i run blockMesh, i receive my desired mesh. But if i run snappyHexMesh afterwards, i receive an error like: Code:
--> FOAM FATAL ERROR: Do you have any hints for me in order to obtain my desired mesh (in snappyHexMesh)? Best regards! http://www.1file.de/uploads/79e8f1bca1.png |
I am having the same issue. Did you find an answer to this?
Thanks |
All times are GMT -4. The time now is 03:57. |