Boundary Mesh refinement
2 Attachment(s)
Hi everyone,
I am having trouble trying to refine the mesh near the walls of a duct using snappyHexMesh. My case is a simple empty straight duct. But I need to get the mesh near all four walls to be about 4 times smaller than those in the centre in both y and z directions. I am not sure if the snappyHexMeshDic file that I modified is correct because when I ran it, the mesh created by blockMesh don't seem to change at all when I open paraview. There was no error though. Can someone help? Regards, Charles |
All times are GMT -4. The time now is 19:49. |