[Technical] Creating 2D cartesian cut cell meshes

hertzsprung · May 15, 2014, 07:22

I've just started using OpenFOAM to investigate atmospheric flow over terrain. I'm looking for suggestions on creating a cut cell mesh to model the terrain as a patch.

I already have code that adapts a regular grid produced by blockMesh to add a mountain using terrain following coordinates. I'm hoping to reuse the ground patch from this mesh in creating the cut cell mesh. Could snappyHexMesh be coaxed into producing such a mesh, or should I look at writing my own application?

hertzsprung · May 20, 2014, 18:03

This is as far as I've got with snappyHexMesh: http://goo.gl/GWUnSJ

I've created an .obj of the ground patch with writeMeshObj and used this as the surface with refinement level (0 0). Any suggestions are most welcome!

May 15, 2014, 07:22	Creating 2D cartesian cut cell meshes	#1
hertzsprung New Member James Shaw Join Date: May 2014 Posts: 8 Rep Power: 12	I've just started using OpenFOAM to investigate atmospheric flow over terrain. I'm looking for suggestions on creating a cut cell mesh to model the terrain as a patch. I already have code that adapts a regular grid produced by blockMesh to add a mountain using terrain following coordinates. I'm hoping to reuse the ground patch from this mesh in creating the cut cell mesh. Could snappyHexMesh be coaxed into producing such a mesh, or should I look at writing my own application?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] edges not aligned with or perpendicular to non-empty directions	ynos	OpenFOAM Meshing & Mesh Conversion	6	March 26, 2020 16:02
FvMatrix coefficients	shrina	OpenFOAM Running, Solving & CFD	10	October 3, 2013 15:38
Cartesian cut cell	Cartesian cut-cell	Main CFD Forum	0	February 26, 2007 19:21
How to cut cell?	KtoTo	Siemens	2	November 19, 2006 22:16
Help for cut cell scheme for moving problems	Wei	Main CFD Forum	0	August 2, 2006 10:32

May 20, 2014, 18:03		#2
hertzsprung New Member James Shaw Join Date: May 2014 Posts: 8 Rep Power: 12	This is as far as I've got with snappyHexMesh: http://goo.gl/GWUnSJ I've created an .obj of the ground patch with writeMeshObj and used this as the surface with refinement level (0 0). Any suggestions are most welcome!