|
[Sponsors] |
[Other] Quality check of the mesh for OpenFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 3, 2014, 03:54 |
Quality check of the mesh for OpenFoam
|
#1 |
New Member
|
Folks,
which are the criteria for quality check of the openfoam mesh? I found as criteria the following, are there any other ? Maximum non-orthogonality allowed; 180 disables Max boundary face skewness allowed; 0 disables Max internal face skewness allowed; 0 disables Which is the equation that calculates the above? Thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Improving mesh quality + inlet too coarse | MartinBlx | OpenFOAM Meshing & Mesh Conversion | 5 | August 2, 2015 22:09 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Mesh check failed | subhas.hunasikatti@gmail. | FLUENT | 0 | January 19, 2014 04:09 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |