Problem with extrudeMesh sHM 2D airfoil mesh
Hi foamers,
I'm trying to make a 2D mesh of an airfoil. First I make a square blockMesh as explained in the openfoam guide. And then I run the following commands Code:
foamClearPolyMesh Code:
Mesh bounding box : (-10 -10 0) (10 10 1) Code:
Mesh bounding box : (-10 -10 -0.5) (10 10 0.5) //correct |
Hi,
read the "final project" documentation by Alejandro Roger Ull http://www.cfd-online.com/Forums/ope...gear-pump.html ->The work consists on meshing the geometry with snappyHexMesh in parallel and extruding it with extrudeMesh to make it two-dimensional. I hope it can be a good guideline for your work. |
Quote:
|
All times are GMT -4. The time now is 21:28. |