blockMesh warning negative volume
Hi guys,
I try to blockMesh my geometry but I get the following warnings when doing so: FOAM Warning: From function cellModel::mag (const labelList&, const pointField&) in file meshes/meshShapes/cellModel/cellModel.c at line 128 zero or negative pyramid volume: -3.3333e+09 for face 1 FOAM Warning: From function cellModel::mag (const labelList&, const pointField&) in file blockMesh/blockMeshTopology.C at line 255 negative volume block: 0, probably defined inside out What is the reason for this? Where can I find meshes/meshShapes/cellModel/cellModel.c and blockMesh/blockMeshTopology.C? Thank you very much in advance for your help |
would you share your blockMeshDict?
|
uuupss, realised my mistake and solved the problem :-)
|
Negative Valumes in BlockMesh
Quote:
What was your mistake ? I'm facing same problem . Regardss Maral |
Hi Maral,
Check the order in which you have defined your vertices and the way you have called them while defining the hex block. As an example, assuming that you are creating a cuboid, the way I would define it is to start at the lower z value, from the bottom left point and continue in a anticlockwise way to the top left point. And then do the same for the higher z value. I have noticed that this way allows you to avoid the inside out problem. Hope this helps. Cheers, Antimony |
All times are GMT -4. The time now is 08:37. |