OFW10 snappyHexMesh Training Session Questions (follow up)
 

Hello All,

As promised at my 10th OpenFOAM Workshop Training on snappyHexMesh, I am starting a questions thread. My hope for this thread is that:

1. If you have a question that you didn't ask during the training you can ask here.
2. If you know the answer to a question that is asked, go ahead and answer and I will do my best to look over and answer the unanswered or provide some additional information.

If you have a question that is not about the training and is more specific to your issue, then I suggest you start a new thread and get a more focused discussion on your new thread. This thread is not a replacement for the user forum

Some important links:

• The ISO file for the workshop is located temporarily at this link.
• The Instructions for installing the ISO are at this link.
• The training slides are located at this link
• Some Useful Links for Learning snappyHexMesh in general are at the snappyHexMesh on the OpenFOAM wiki

Please not that the links to the workshop tend to change at some point to a more permanent location so these are temporary before they are hosted on the OpenFOAM extend SourceForge project.

hi
The ISO file download link is expired!
how can i download it?
I really need it for my project.
thanks in advance

During the workshop we had some issues with bandwidth so we hosted it at a dropbox that was temporary. Until we can find a more permanent place, the ISO can be downloaded From this link.

Remember, there where also some instructions on how to load the ISO in a virtual machine in the top post of this thread. I hope this helps.

Best Regards,

Thanks for your attention and help Mr.combest it helped so much.
I'm very grateful