Meshing a diffuser using snappyhex problem?
 

Hello Foamers,

I hope that you all are well. I am new to openFoam. I am trying to mesh a diffuser inside a cube. I have created the stl file using solidworks and made sure that the diffuser is inside the blockMesh for the file that I have created using paraview. I have changed the patches inside the snappyhexmesh file to match the stl file. Furthermore, I have applied the following commands:
1- blockMesh
3- decompserdec
3- mpirun -np 6 snappyHexMesh -overwrite -parallel
4- reconstructParMesh -constant
So far, I am unable to get any results. Please if anyone could find sometime to help me out in this regard.

Thanks in advance,

http://www.mediafire.com/download/3t...ffuser1.tar.gz

Anybody have some time
 

:mad: I have tried but noting has happened up until now...