CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (https://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   [Other] 3D Mesh of a wind turbine blade. Which tool to use? (https://www.cfd-online.com/Forums/openfoam-meshing/171666-3d-mesh-wind-turbine-blade-tool-use.html)

WhiteW May 13, 2016 04:11

3D Mesh of a wind turbine blade. Which tool to use?
 
1 Attachment(s)
Hi to everyone.
I would like to create the 3D model of an HAWT blade and then generate a 3D mesh for a further simulation in OpenFOAM.
The 3D mesh is composed by a boundary layer(from a surface quad structured mesh), and an external zone of tetra elements.
I was exploring Salome in order to create the 3D model, but then? What is the most suitable meshing tool to do a 3D structured-non structured mesh for openFOAM?
Thanks,
WhiteW


All times are GMT -4. The time now is 08:58.