 |
 |
 |
|
|
|
[Sponsors] | ||||
[surface handling] surfaceFeatureExtract in Foam Extend 3.2 |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 7, 2017, 21:08
|
surfaceFeatureExtract in Foam Extend 3.2
|
#1 |
|
Member
Ashish Kumar
Join Date: Jun 2015
Posts: 33
Rep Power: 10  |
I am facing a problem with surfaceFeatureExtract in Foam Extend 3.2
I am using the following command surfaceFeatureExtract -includedAngle 150 -writeObj constant/triSurface/geom.stl But it shows this error --> FOAM FATAL ERROR: Wrong number of arguments, expected 2 found 1 Invalid option: -writeObj |
|
|
|
|
|
October 12, 2017, 04:53
|
|
#2 |
|
Member
Katt
Join Date: May 2017
Posts: 30
Rep Power: 8 |
Hi,
Have you found out how to do this. I am in need of the same for foam-Extend 1.6. |
|
|
|
|
|
|
October 12, 2017, 08:54
|
|
#3 | |
|
Member
Ashish Kumar
Join Date: Jun 2015
Posts: 33
Rep Power: 10 |
Quote:
|
||
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| error with reactingFoam | BakedAlmonds | OpenFOAM Running, Solving & CFD | 4 | June 22, 2016 02:21 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| [Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |
Linear Mode
