[snappyHexMesh] SnappyHexMesh does not add layer in edges

c.willer · December 2, 2016, 13:12

Hello Forum,

I have added layers to a cylinder but at the edge the layer is not continued until the edge. I us the same patch (Outlet) for the layer but I can not figure out why at the edge I can not get layers. Do I have to change some settings? Attached I added some pictures and the code of snappyHexMeshDict.

If somebody has any idea please let me know.

Christian

Bildschirmfoto1.jpeg

Bildschirmfoto2.jpeg

Bildschirmfoto3.jpeg

Bildschirmfoto11.jpg

snappyHexMeshDict.txt

FlyingCat · March 24, 2017, 09:28

Hi,

I have already had some problems like that. SnappyhexMesh does not seem to be very efficient to add layers, especially in corners. I have not found any solutions on the internet.

For me, the best solution is to use refinementSurface.

December 2, 2016, 13:12	SnappyHexMesh does not add layer in edges	#1
c.willer New Member Christian Join Date: Dec 2016 Location: Germany Posts: 1 Rep Power: 0	Hello Forum, I have added layers to a cylinder but at the edge the layer is not continued until the edge. I us the same patch (Outlet) for the layer but I can not figure out why at the edge I can not get layers. Do I have to change some settings? Attached I added some pictures and the code of snappyHexMeshDict. If somebody has any idea please let me know. Christian Bildschirmfoto1.jpeg Bildschirmfoto2.jpeg Bildschirmfoto3.jpeg Bildschirmfoto11.jpg snappyHexMeshDict.txt

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Error snappyhexmesh - Multiple outside loops	avinashjagdale	OpenFOAM Meshing & Mesh Conversion	53	March 8, 2019 09:42
[snappyHexMesh] Old and busted: snappyHexMesh and add layers with edges	Siassei	OpenFOAM Meshing & Mesh Conversion	6	August 14, 2018 18:33
[snappyHexMesh] Problem with snappyhexMesh: modelling a pore chamber and pore throat model	Saideep	OpenFOAM Meshing & Mesh Conversion	5	May 10, 2015 14:46
[snappyHexMesh] collapsed edges snappyHexMesh	ynos	OpenFOAM Meshing & Mesh Conversion	1	April 16, 2014 08:23
[snappyHexMesh] SnappyHexMesh Internal Flow Example (Diesel Injector)	Irish09	OpenFOAM Meshing & Mesh Conversion	23	July 15, 2013 07:45

March 24, 2017, 09:28		#2
FlyingCat Member Jean bon Join Date: Sep 2016 Posts: 43 Rep Power: 9	Hi, I have already had some problems like that. SnappyhexMesh does not seem to be very efficient to add layers, especially in corners. I have not found any solutions on the internet. For me, the best solution is to use refinementSurface.