|
[Sponsors] |
[Salome] no 3D mesh for 2D geometry in Salome |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 8, 2017, 13:44 |
no 3D mesh for 2D geometry in Salome
|
#1 |
Senior Member
Bill Wang
Join Date: Aug 2014
Posts: 109
Rep Power: 11 |
Dear,
I am trying to mesh a 2D geometry in salome. The geometry was created via the extrusion of a face. I have defined the algorithms and hypotheses as shown in the picture. But the mesh generation is always failed. I am really appreciated for any kind help. Since the salome file is very large, I could send you via email, if possible. Thank you in advance. Best Regards, Bill Last edited by 6863523; February 11, 2017 at 09:33. Reason: wrong info |
|
February 11, 2017, 09:32 |
mesh computation failed
|
#2 |
Senior Member
Bill Wang
Join Date: Aug 2014
Posts: 109
Rep Power: 11 |
Dear,
I wonder why this problem occur? I have tried other geometries and there is no error? Could any one give some suggestions? Thank you in advance. Best Regards, Bill |
|
February 11, 2017, 12:06 |
Solved
|
#3 |
Senior Member
Bill Wang
Join Date: Aug 2014
Posts: 109
Rep Power: 11 |
I found a link here
http://www.salome-platform.org/forum/forum_10/138954355 Hope this will help the new learners of Salome. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
[ICEM] Copy geometry then copy mesh | Anna Tian | ANSYS Meshing & Geometry | 0 | July 30, 2012 16:59 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
salome, openfoam and moving mesh | prhlava | OpenFOAM Running, Solving & CFD | 8 | November 9, 2009 08:59 |
unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 10:09 |