|
[Sponsors] |
August 16, 2017, 06:31 |
Cylinder using snappyHex
|
#1 |
Member
AndreiCFD
Join Date: Nov 2012
Posts: 47
Rep Power: 13 |
Hi OFoamers,
I am trying to mesh a cylinder using snappyHEX and after trying pretty much all the setting I can't figure out why is not growing layers. Any suggestions will be much appreciated. I have attached the case file. Many thanks Cheers, Andrei |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flow past a 2D cylinder - High Re (1E+05) - Cd too high | Pervispasco | OpenFOAM Running, Solving & CFD | 4 | March 14, 2022 02:19 |
Drag force coefficient too high for a flow past a cylinder using komega sst | Scabbard | OpenFOAM Running, Solving & CFD | 37 | March 21, 2016 16:16 |
Forces Acting on a Rotating Cylinder (Moving Mesh) | dreamchaser | CFX | 5 | April 25, 2015 06:01 |
Incorrect Drag and Drag Coefficient for flow over a cylinder | ozzythewise | Main CFD Forum | 8 | June 13, 2012 06:24 |
[blockMesh] Specifying boundary faces failes in blockMesh | blaise | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2010 03:56 |