[ldevivo]

Hello all,

I am looking for some advice on how can I improve the mesh quality of my simulation. I am studying the aerodynamic flow over a wing.
The geometry can be seen in the image below:
Capture.PNG

The problem happens after I run the snappymesh and before I can run the simulation. I realized there is a section at the trailing edge of the wing where the mesh becomes irregular and fails to recognize the actual geometry.
The mesh parameters used were:

cell size (0.1,0.1,0.1)
refine level (4,6)
and the wingspan is about 3 m long

Capture1.PNG

I am wondering if you have any idea on how to fix this or what may be causing this error.

Thanks