|
[Sponsors] |
[mesh manipulation] Mesh refining with progression |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 14, 2017, 08:53 |
Mesh refining with progression
|
#1 |
Member
Join Date: Jun 2017
Posts: 73
Rep Power: 8 |
Hello everyone,
I would like to know if there is any possiblity to refine a mesh towards a face with a progression. For Example: I Have 4 cells in z-direction and using refineMesh would make 4x4 = 16 cells, which are equally big, but I would like to have the first cells 2 times bigger than the next one e.g. and so on. I know that you can give the lines of the mesh a progression but want to know if there is a possibily with refineMesh. The Mesh is built with GMSH. Greetings, Friendly |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
[ANSYS Meshing] guidance about refining hex mesh? | hamidciv | ANSYS Meshing & Geometry | 15 | July 27, 2015 03:28 |
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 08:05 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 04:52 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |