[snappyHexMesh] addLayersControls does not generate boundary layers

rinaldialberto · July 12, 2018, 05:20

Dear all,

I am having problems in creating boundary layers around a simple extruded geometry.
I tried to play around with nSurfaceLayers, expansionRatio, finalLayerThickness, minThickness,relativeSizes.

Is somebody able to help me in creating the bl?

I attach the blockMeshDict, the stl geometry and snappyHexMeshDict I am using.

Cheers
Alberto Rinaldi

kera · July 12, 2018, 09:14

Hallo Alberto,

set addLayers to true.

Code:

// Which of the steps to run
castellatedMesh true;
snap            true;
addLayers       true;

Regards,
Ricky

Quote:

Originally Posted by rinaldialberto

Dear all,

I am having problems in creating boundary layers around a simple extruded geometry.
I tried to play around with nSurfaceLayers, expansionRatio, finalLayerThickness, minThickness,relativeSizes.

Is somebody able to help me in creating the bl?

I attach the blockMeshDict, the stl geometry and snappyHexMeshDict I am using.

Cheers
Alberto Rinaldi

rinaldialberto · July 12, 2018, 11:22

Quote:

Originally Posted by kera

Hallo Alberto,

set addLayers to true.

Code:

// Which of the steps to run
castellatedMesh true;
snap            true;
addLayers       true;

Regards,
Ricky

haha no way.

Sorry for having asked such a stupid question.

Thanks a lot Ricky,
Cheers
Alberto

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[cfMesh] boundary layers	JensD	OpenFOAM Community Contributions	6	September 26, 2022 05:59
Radiation in semi-transparent media with surface-to-surface model?	mpeppels	CFX	11	August 22, 2019 07:30
An error has occurred in cfx5solve:	volo87	CFX	5	June 14, 2013 17:44
Error finding variable "THERMX"	sunilpatil	CFX	8	April 26, 2013 07:00
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55