[mesh manipulation] extrudeMesh for buffer in a pipe

cfd4res · January 25, 2019, 05:29

I came across this problem while creating a mesh for a pipe with many bends using blockMesh and extrudeMesh.
As seen in the figure below , I created a pipe using the project feature and then used extrudeMesh to create a bend. But I cannot create the buffer as I wanted as I cannot increase the diameter of the pipe.

Figure.jpg

I think I need to use three different files to create the buffer zone in the pipe.

Can anyone please help me with this?

jherb · January 28, 2019, 12:25

You could use extrudeMesh to create the pipe without the modified area in the buffer zone and then a Python script using this library (https://codereview.stackexchange.com/a/101298) to modify the node locations of the nodes inside the buffer. (Should not be too hard, because you know the z-coordinates of the buffer, so you can search for the nodes and modify their x/y values accordingly).

January 25, 2019, 05:29	extrudeMesh for buffer in a pipe	#1
cfd4res New Member anonymous Join Date: Mar 2018 Posts: 11 Rep Power: 8	I came across this problem while creating a mesh for a pipe with many bends using blockMesh and extrudeMesh. As seen in the figure below , I created a pipe using the project feature and then used extrudeMesh to create a bend. But I cannot create the buffer as I wanted as I cannot increase the diameter of the pipe. Figure.jpg I think I need to use three different files to create the buffer zone in the pipe. Can anyone please help me with this?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[DesignModeler] DesignModeler Pipe within pipe	shields	ANSYS Meshing & Geometry	13	November 25, 2018 22:14
[mesh manipulation] extrudeMesh for pipe with changing cross section	cfd4res	OpenFOAM Meshing & Mesh Conversion	0	March 18, 2018 11:08
[mesh manipulation] extrudeMesh for pipe bend	cfd4res	OpenFOAM Meshing & Mesh Conversion	0	March 15, 2018 13:04
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 21:31

January 28, 2019, 12:25		#2
jherb Senior Member Joachim Herb Join Date: Sep 2010 Posts: 650 Rep Power: 21	You could use extrudeMesh to create the pipe without the modified area in the buffer zone and then a Python script using this library (https://codereview.stackexchange.com/a/101298) to modify the node locations of the nodes inside the buffer. (Should not be too hard, because you know the z-coordinates of the buffer, so you can search for the nodes and modify their x/y values accordingly).