|
[Sponsors] |
December 6, 2018, 11:16 |
Poor coverage layer
|
#1 |
New Member
Gabriel
Join Date: Jun 2016
Posts: 5
Rep Power: 9 |
Hello,
I am having bad layer coverage as seen on attached screenshots. I consider the snapping good, but have no clue on how to improve the layer process, those are my setting at the moment: expansionRatio 1.2; finalLayerThickness 0.5; minThickness 0.1; nGrow 0; featureAngle 180; slipFeatureAngle 30; nRelaxIter 5; nSmoothSurfaceNormals 1; nSmoothNormals 3; nSmoothThickness 10; maxFaceThicknessRatio 0.5; maxThicknessToMedialRatio 0.3; minMedianAxisAngle 90; nBufferCellsNoExtrude 0; nLayerIter 70; nRelaxedIter 30; I did several trials changing featureAngle and slipFeatureAngle, but no visible change. Could anyone help me, please? *Edit: thanks to this publication I found help and solved the problem! Last edited by gm2gabriel; December 10, 2018 at 11:27. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Help with Snappy: no layers growing | GianF | OpenFOAM Meshing & Mesh Conversion | 2 | September 23, 2020 08:26 |
[snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 05:53 |
Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |