 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] splitMeshRegion problem(cell in multi zones) |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 10, 2019, 10:52
|
splitMeshRegion problem(cell in multi zones)
|
#1 |
|
New Member
huangkai
Join Date: May 2017
Posts: 3
Rep Power: 8  |
Hi everyone, I'm a newer studying OpenFoam, and I want to use chtMultiRegionFoam to solve problem about heat transfer from the outside of tube to inner air. I followed other's work and used a "o" mesh methods. Then topoSet air and glass region, next splitMeshRegion. In this procedure, a problem about "cell in multi zones" happens. Dose anyone can give me some ideas about this problem? Maybe this tube mesh generation method is not suitable about this problem? "blockMeshDict" and "topoSetDict" are attached.Thank you!blockMeshDict_topoSetDict.tar.gz
|
|
|
|
|
|
| Tags |
| chtmulitregionfoam, splitmeshregions, toposet |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] preserveFaceZones constraint on a multi region mesh | ViktorKL | OpenFOAM Meshing & Mesh Conversion | 5 | May 21, 2019 11:45 |
| [ANSYS Meshing] Is it possible to generate mesh in different cell zones in Ansys meshing? | aja1345 | ANSYS Meshing & Geometry | 0 | October 3, 2018 14:22 |
| Building problems with cell zones when reopening Fluent | MJ2017 | FLUENT | 0 | October 14, 2017 08:11 |
| multi fluid zones | gharika90 | ANSYS Meshing & Geometry | 3 | June 19, 2014 14:19 |
| boundary condition between multi zones for UDS | lx33101128 | FLUENT | 0 | May 10, 2011 11:12 |
Linear Mode
