Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[blockMesh] Trapezoidal Prism meshing

Mark Forums Read

Reply

Search this Thread

May 29, 2019, 06:09	Trapezoidal Prism meshing	#1
SWAPNASRITA New Member odisha Join Date: Dec 2016 Posts: 8 Rep Power: 10	Hello, I want to make a trapezoidal prism using blockMesh. The mesh does not need to be uniform necessarily. Can anyone guide me as to how to achieve that? Regards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Parallel meshing utilisation failing	crc1622	ANSYS Meshing & Geometry	0	February 14, 2019 03:42
[ICEM] No prism meshing	phPatras	ANSYS Meshing & Geometry	0	July 23, 2015 12:17
why prism meshing near wall?	avinashjagdale	Main CFD Forum	3	February 17, 2014 07:06
[ICEM] Prism meshing	itsayapan	ANSYS Meshing & Geometry	2	May 28, 2010 05:52
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 12:08

All times are GMT -4. The time now is 23:42.