 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] problem with SHM conforming to geometry |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 19, 2019, 04:13
|
problem with SHM conforming to geometry
|
#1 |
|
New Member
Malini Dasgupta
Join Date: Mar 2019
Location: Germany
Posts: 6
Rep Power: 7  |
Hello,
I am relatively new with SHM I have been struggling for a couple of days with meshing a wedge with a slit as shown in the screenshot. The mesh doesn't conform well with the geometry. This might be a typical problem. But since I am quite new to this, I exactly don't know where to begin with to resolve these sharp edges. I have tried to play around with the resolveFeatureAngle but it too did not help. I am also attaching a link to my case files. https://drive.google.com/open?id=1OX...U5HdKbwB5PR94d Any help will really be appreciated at this point Regards, Malini |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Volume Meshing Problem; YOUR GEOMETRY HAS A HOLE | mariachi | ANSYS Meshing & Geometry | 5 | May 30, 2018 02:52 |
| Problem with building geometry - concentric cylinders | Rhoddwen | OpenFOAM Pre-Processing | 9 | December 17, 2014 10:02 |
| Problem with geometry - concentric cylinders | Rhoddwen | OpenFOAM Running, Solving & CFD | 0 | December 15, 2014 09:22 |
| problem when imported geometry from 3D CAD to star ccm, | TAREK GANAT | STAR-CCM+ | 1 | May 21, 2013 22:15 |
| [Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 04:53 |
Linear Mode
