 |
 |
 |
|
|
|
[Sponsors] | ||||
June 24, 2019, 03:56
|
Adding layers snappyhexmesh
|
#1 |
|
New Member
Ashish Tiwari
Join Date: May 2018
Posts: 3
Rep Power: 7  |
Hi,
I have been trying hard to increase the number of layers on Ahmed car body. I have read many tutorials and I see that the number of layers is quite low for the tutorial cases I.e. below 5 or 6. I think the Ansys guidelines require at least 10 number of layers. How can one justify his solution based upon small number of layers ? Secondly,Apart from feature angle and maxthicknesstomedial ratio,is there something I should try with? |
|
|
|
|
 |
| Tags |
| openfoam 5, snapphhexmesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| multiRegionHeater error | ordinary | OpenFOAM Running, Solving & CFD | 2 | June 9, 2020 17:43 |
| conjugateHeatFoam + interFoam | farhagim | OpenFOAM Programming & Development | 15 | July 19, 2016 07:55 |
| [snappyHexMesh] snappyHexMesh not adding layers to a solid | jet_engine | OpenFOAM Meshing & Mesh Conversion | 0 | June 3, 2016 08:25 |
| [snappyHexMesh] Adding layers goes wrong with SnappyHexMesh | Elise | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 02:32 |
| [snappyHexMesh] SnappyHexMesh doesn't succeed in adding several layers | eti0123456789 | OpenFOAM Meshing & Mesh Conversion | 5 | April 9, 2013 02:36 |
Linear Mode
