 |
 |
 |
|
|
|
[Sponsors] | ||||
[Commercial meshers] Simple rotating zone with AMI |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 26, 2021, 10:51
|
Simple rotating zone with AMI
|
#1 |
|
New Member
Join Date: Jan 2019
Posts: 11
Rep Power: 7  |
Hi everyone,
I am trying to use the AMI to simulate a simple rotating zone. I generated the mesh with Ansys meshing you can see: 1.jpg I created the mesh with two different domains so there is no connection between the points. FOAM sees this connection as a wall. I searched this and I should create baffle from this internal wall I guess? I added the contact zone also: 2.JPG I dont know what steps should I follow after converting the mesh or should rotating and static domains have connected nodes. I also added the mesh file if it helps. |
|
|
|
|
|
August 3, 2023, 14:08
|
|
#2 |
|
New Member
Sebastián Agudelo
Join Date: Feb 2021
Posts: 6
Rep Power: 5 |
Hi Klitz, were you able to solve this problem?
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rotating Mesh - Mesh Overlap/Discontinuity At Boundary Interface | sai95kamal | FLUENT | 1 | June 15, 2020 08:58 |
| Simple piston movement in cylinder- fluid models | arun1994 | CFX | 4 | July 8, 2016 02:54 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [ICEM] Rotating Mesh and export Mesh | ahmadreza | ANSYS Meshing & Geometry | 10 | July 12, 2015 04:17 |
| [snappyHexMesh] 2D AMI Moving Mesh with sHM; How hard can this be? | ADGlassby | OpenFOAM Meshing & Mesh Conversion | 18 | June 18, 2013 06:07 |
Linear Mode
