CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Meshing & Mesh Conversion (
-   -   [mesh manipulation] Skewed cells after mergeOrSplitBaffles (

Biotech September 9, 2019 12:51

Skewed cells after mergeOrSplitBaffles
1 Attachment(s)
Hello together

I have a problem with skewed cells. If I check the grid after snappyHexMesh everything is fine. However, if I use the createBaffles and mergeOrSplitBaffles -split commands, I get skew cells around the AMI zone (As in tutorial

I have already tried different refinements of the grid, but without success.
Can someone help me with this problem?

Thank you so much for your support.


All times are GMT -4. The time now is 20:16.