 |
 |
 |
|
|
|
[Sponsors] | ||||
[mesh manipulation] Skewed cells after mergeOrSplitBaffles |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 9, 2019, 12:51
|
Skewed cells after mergeOrSplitBaffles
|
#1 |
|
New Member
anonymous
Join Date: Sep 2019
Posts: 1
Rep Power: 0  |
Hello together
I have a problem with skewed cells. If I check the grid after snappyHexMesh everything is fine. However, if I use the createBaffles and mergeOrSplitBaffles -split commands, I get skew cells around the AMI zone (As in tutorial https://github.com/OpenFOAM/OpenFOAM...mixerVesselAMI). I have already tried different refinements of the grid, but without success. Can someone help me with this problem? Thank you so much for your support. Biotech |
|
|
|
|
|
January 31, 2025, 10:15
|
|
#2 |
|
New Member
Nicholas Langbein
Join Date: Nov 2024
Posts: 21
Rep Power: 2 |
Hello,
I am now facing the same issue in same case mixerVesselAMI. could you please share how was it resolved |
|
|
|
|
|
|
| Tags |
| ami patches, skewed cells, snappyhexmesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] sHM - flat-/ double lined cells | pconen | OpenFOAM Meshing & Mesh Conversion | 1 | February 1, 2023 05:40 |
| [snappyHexMesh] Layers not growing at all | zonda | OpenFOAM Meshing & Mesh Conversion | 12 | June 6, 2020 12:28 |
| [snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 09:07 |
| [snappyHexMesh] snappyHexMesh Segmentation Fault | avd28 | OpenFOAM Meshing & Mesh Conversion | 11 | May 11, 2015 21:32 |
| [snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 04:23 |
Linear Mode
