|
[Sponsors] |
[snappyHexMesh] Help in finding the formula to calculate the final layer thickness |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 10, 2019, 03:13 |
Help in finding the formula to calculate the final layer thickness
|
#1 |
New Member
Srinivasan
Join Date: Jun 2018
Location: India
Posts: 2
Rep Power: 0 |
Hi everyone,
Hope everyone is doing good, I am a new member here. Just have a very small question. I am using SnappyHexMesh to mesh my component and i want to create layers. I found out that if I provide final layer thickness, it works more better than providing first layer thickness. I have the forumla to calculate the first layer thickness when using relative sizes. can someone help me to find the formula to calculate the final layer thickness using the required first cell height and expansion ratio. hoping to interact with you all Thanks and Regards Srinivasan M |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with chtMultiregionFoam radiation boundary condition | baran_foam | OpenFOAM Running, Solving & CFD | 10 | December 17, 2019 17:36 |
Foam::error::printStack after large bounding epsilon events | StoneCFD727 | OpenFOAM Running, Solving & CFD | 1 | January 1, 2018 17:04 |
Free surface issues with interDyMFoam for hydroturbine | oumnion | OpenFOAM Running, Solving & CFD | 0 | October 6, 2017 14:05 |
Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 18:17 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |