 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] Tire on floor Simulation dynamic mesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 19, 2020, 09:23
|
Tire on floor Simulation dynamic mesh
|
#1 |
|
Member
Join Date: Feb 2020
Posts: 90
Rep Power: 6  |
Hello to all,
Currently I am trying to perform a simulation of a tire rolling a floor. I intended to use the FSI toolbox solids4Foam for the analysis. I think I will have to set a dynamic mesh for this, however I do not have any experience with it and was hopping you guy could give me a hand. The problem has a rotation and translation. Can I set this with 6DoF? Should I use overset mesh? Best Regards, 
|
|
|
|
|
|
February 19, 2020, 17:27
|
|
#2 |
|
Senior Member
Herpes Free Engineer
Join Date: Sep 2019
Location: The Home Under The Ground with the Lost Boys
Posts: 932
Rep Power: 12 |
please refer below.
__________________
The OpenFOAM community is the biggest contributor to OpenFOAM: User guide/Wiki-1/Wiki-2/Code guide/Code Wiki/Journal Nilsson/Guerrero/Holzinger/Holzmann/Nagy/Santos/Nozaki/Jasak/Primer Governance Bugs/Features: OpenFOAM (ESI-OpenCFD-Trademark) Bugs/Features: FOAM-Extend (Wikki-FSB) Bugs: OpenFOAM.org How to create a MWE New: Forkable OpenFOAM mirror |
|
|
|
|
|
|
| Tags |
| dynamic mesh, fsi |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ship resistance shows wiggles when using Overset mesh and dynamic mesh in Fluent | Qingsong | FLUENT | 2 | March 21, 2022 15:08 |
| Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 08:27 |
| [ICEM] Dynamic mesh setup with ICEM | David121284 | ANSYS Meshing & Geometry | 0 | April 11, 2014 04:19 |
| Dynamic Mesh "Shadow Wall" | thezack | FLUENT | 0 | June 4, 2013 22:09 |
| dynamic mesh for drop interface | IndrajitW | FLUENT | 0 | March 30, 2013 08:03 |
Linear Mode
