Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[surface handling] Point inside a face

Mark Forums Read

Reply

Search this Thread

May 20, 2020, 06:53	Point inside a face	#1
anhkenyt New Member Duc Anh Join Date: Dec 2018 Posts: 22 Rep Power: 7	Hi foamer, I found a project of point in a face, but I have no idea to check its inside. Is there a way to determine if an arbitrary point is inside a face?

Reply

Tags

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem in toposet	Ahmed Khattab	OpenFOAM Pre-Processing	27	March 3, 2023 21:12
[mesh manipulation] Importing Multiple Meshes	thomasnwalshiii	OpenFOAM Meshing & Mesh Conversion	18	December 19, 2015 18:57
[snappyHexMesh] snappyHexMesh and cyclic boundaries	Ruli	OpenFOAM Meshing & Mesh Conversion	2	December 9, 2013 06:51
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 13:06

All times are GMT -4. The time now is 18:23.