|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Duc Anh
Join Date: Dec 2018
Posts: 22
Rep Power: 5 ![]() |
Hi foamer,
I found a project of point in a face, but I have no idea to check its inside. Is there a way to determine if an arbitrary point is inside a face? |
|
![]() |
![]() |
![]() |
Tags |
mesh 2d |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem in toposet | Ahmed Khattab | OpenFOAM Pre-Processing | 25 | April 30, 2021 02:07 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
[snappyHexMesh] snappyHexMesh and cyclic boundaries | Ruli | OpenFOAM Meshing & Mesh Conversion | 2 | December 9, 2013 06:51 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |