|
[Sponsors] |
[blockMesh] Can i specify an obstacle as a wall which is part of internal geometry using blockmes |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 22, 2020, 07:51 |
Can i specify an obstacle as a wall which is part of internal geometry using blockmes
|
#1 |
New Member
Shoaib
Join Date: Sep 2020
Posts: 1
Rep Power: 0 |
Can i specify an obstacle as a wall which is part of internal geometry using blockmeshdict?
This is Dambreak analysis case,using Interfoam. dam2.png this is my geometry. dambreak.png here is the internal part of the geometry (Obstacle). An obstacle height is 0.8m and total height is 3.6m, Firstly the most important i want to know that can i specify this internal part of my geometry (Obstacle) as a wall or not using blockmeshDict? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
[ANSYS Meshing] How to change the type of "zero wall thickness" internal baffle to "Internal" | prasa | ANSYS Meshing & Geometry | 0 | March 7, 2016 12:08 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
2 Sided wall on 3D geometry | Frederic | FLUENT | 2 | January 4, 2005 00:51 |