Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[mesh manipulation] nonManifoldPoints when using fluent3DMeshToFoam

Updated Threads

Reply

Search this Thread

November 21, 2020, 00:53	nonManifoldPoints when using fluent3DMeshToFoam	#1
Jasper Z Member Huan Zhang Join Date: Nov 2020 Posts: 55 Rep Power: 5	Hi all, I was wondering what does nonManifoldPoints mean? the checkMesh writes: "<<Writing 503452 conflicting points to set nonManifoldPoints" But I am running my case normally. Can anyone please explain what's the meaning of nonManifoldPoints? Will it affect the results? Thank you in advance!

April 6, 2022, 02:14		#2
Jury New Member Chris Join Date: Nov 2021 Posts: 12 Rep Power: 4	Same problem here. Can anyone give us a hint?

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
fluent3DMeshToFoam and mergeMeshes crash with large (around 170 mio cells) meshes	maxdre91	OpenFOAM Pre-Processing	2	April 27, 2022 08:44
nonManifoldPoints when using fluent3DMeshToFoam	Jasper Z	OpenFOAM	5	August 11, 2021 03:08
periodic (cyclic) boundary - fluent3DMeshToFoam	cyln	OpenFOAM	1	October 17, 2017 02:59
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam)	cfdonline2mohsen	OpenFOAM	3	October 21, 2013 09:28
OpenFOAM command from inside MATLAB	sega	OpenFOAM Post-Processing	18	September 25, 2012 07:35

All times are GMT -4. The time now is 02:05.