CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (https://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   [snappyHexMesh] Unknown Issue When Refining Mesh in Area of Interest (https://www.cfd-online.com/Forums/openfoam-meshing/235509-unknown-issue-when-refining-mesh-area-interest.html)

Gregdw99 April 17, 2021 07:36

Unknown Issue When Refining Mesh in Area of Interest
 
Hello,

I am currently investigating the effect of surface contamination over a laminar flow aerofoil (S1210). When using snappyHexMesh to refine the mesh around the aerofoil and wake zone, snappyHexMesh will only refine the aerofoil - but not the wake zone.

I have tried to fix this following the tutorial resources available for OpenFOAM but nothing has helped. Can anyone offer advice on why this might be/how to resolve the issue? I have defined the bounding box large enough to be included in the refinement area and I'm not sure how to proceed.

Thanks in advance,

Greg

AtoHM April 18, 2021 04:44

Without an image and your dictionaries it is impossible to say anything.


All times are GMT -4. The time now is 09:23.