 |
 |
 |
|
|
|
[Sponsors] | ||||
[mesh manipulation] dynamicInkJetFvMesh class explanation and tutorial case |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 27, 2022, 09:08
|
dynamicInkJetFvMesh class explanation and tutorial case
|
#1 |
|
New Member
Rushil
Join Date: Dec 2022
Posts: 3
Rep Power: 2  |
Hey everyone!
I am modelling a synthetic jet and studying its heat transfer properties in OpenFOAM. To achieve the sinusoidal motion of inlet boundary, I realize that dynamicInkJetFvMesh class is to be used. However I am yet to find some resources online to completely understand how this class works. This thesis paper is the only material I could find - http://www.tfd.chalmers.se/~hani/kur..._Corrected.pdf But it does not describe apply for my case. Any tutorials/research papers on this topic will be highly appreciated. Thanks! |
|
|
|
|
|
| Tags |
| dynamic meshing, synthetic jet |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| looking for explanation of v2012 simpleCar tutorial | boffin5 | OpenFOAM Running, Solving & CFD | 0 | July 21, 2021 13:42 |
| Running hotRoom tutorial at low pressure causes fatal error "Negative initial temp?" | massive_turbulence | OpenFOAM Running, Solving & CFD | 2 | January 5, 2019 13:09 |
| Explanation of thermophysical variables (e.g. kappa) + tutorial example | MBttR | OpenFOAM Running, Solving & CFD | 10 | August 8, 2016 02:34 |
| Explanation of airFoil2D tutorial in OpenFOAM | akku | OpenFOAM Running, Solving & CFD | 0 | February 28, 2013 00:21 |
Linear Mode
