Merge adjoining cellsregions
Dear Foamers,
I have a submesh constructed as a fvMeshSubset from a 3D pipe geometry, figure below. The constructed mesh in this case is one cell thick to represent a 1D mesh. Since the cells in the bend are hanging loose OF sees the mesh as having several non-face-coupled regions. Is there a way to merge the cells in the bend to obtain a single "correct" mesh to calculate on? Regards /Niklas W http://www.cfd-online.com/OpenFOAM_D...es/1/11297.jpg |
All times are GMT -4. The time now is 19:49. |