 |
 |
 |
|
|
|
[Sponsors] | ||||
[mesh manipulation] Refining mesh in engineFoam |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 26, 2008, 08:50
|
Refining mesh in engineFoam
|
#1 |
|
New Member
Johan Svensson
Join Date: Mar 2009
Posts: 10
Rep Power: 18  |
Hi everybody,
I just wonder if anyone knows how to refine the mesh within a specific area (close to the ignition site) in the engineFoam/KivaTest tutorial. Thanks in advance, Johan |
|
|
|
|
|
December 2, 2008, 04:58
|
Hi again,
I mean, I need a
|
#2 |
|
New Member
Johan Svensson
Join Date: Mar 2009
Posts: 10
Rep Power: 18 |
Hi again,
I mean, I need a very fine mesh around the ignition site to be able to continue on my thesis work. Is it possible to produce a blockMeshDict and implement it into the geometry of the cylinder in the engineFoam/kivaTest tutorial? Or is there any other way to do it? There must be a way to refine the mesh around the ignition site, or I really hope so.. Anyone who knows anything or has any suggestions is very welcome to reply. Thanks, Johan |
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 08:34 |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 18:16 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
| mesh motion setup in enginefoam | conceptone | OpenFOAM | 0 | October 22, 2012 17:40 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |
Linear Mode
