Why are hex meshes better than tet?
 

Hi,


I have been looking around a bit for a while and I can't seem to find why hex meshes are better than tet meshes, in finite volumes.

I was able to find papers for finite element, but not finite volume.

Can anybody point me in the right direction to where I might read up on this, or even briefly explain why?


Best Regards,

Philip

Wolfgang,

Thanks very much for enlightening me.

So in general, hex are more accurate and take less time.

Best Regards,
Philip

That's right. Also, a tet mesh can have very skewed cells, especially when your geometry contains different shapes (e.g. a cube in a relatively small cylinder).

Gijsbert,

Thanks for the reply.

I have one more question:

How does the cell shape affect convergence of the solution?

I have found that if I use quite skewed cells, then my case will not converge.
Is this a general rule or how does the cell shape affect convergence?

Thanks,
Philip

Skewed elements are sometimes "bad" because the fluxed over their boundaries are calculated wrong and have to be treated with "corrected" schemes.

I can give you some literature reference about that, but I have to look it up.

Hi Sega,

I would love if you could give me some literature reference, that would be great!

Thanks you.

Philip

Also, does all this apply equally to stress analysis as it does to fluid dynamics?

Hi.

Have a look at this picture

http://therealsega.th.funpic.de/open...thogalgrid.jpg
It may illustrate the basic problem when dealing with skewed elements (so called non-othogonal grids).
Basically when interpolating from the cell centers to the face the midpoint of the face is not matched with the connecting line between the two cell centers thus creating a erroneous flux.

You can deal with it by using corrected schemes (first of all for snGrad!).
The "strength" of the correction can by controlled by the entry behind nOrthogonalCorrectors. (There has been a discussion about this entry before.)

The above picture is from:
M. Schäfer. Computational Engineering. Springer 2008. (Chapter 4.5).
And there are some lines at
Ferziger. Computational Methods for Fluid Dynamics. Springer 2002 (Chapter 8.6.2 I think).

Hope this helps. Have a nice day.
http://therealsega.th.funpic.de/open...ogonalgrid.jpg

Sega,

Thanks you very much, this really helps.

I will have a look through Schafer and Ferziger, and I will also have a look around the forum.

Kind Regards,
Philip

Hex vs Tet Help, please
 

Hello Everyone!

Sorry for posting on this quite old forum...

I'm pretty new to the CFD simulation process and I'm still learning about the pros and cons of Hexes vs Tets. According to my investigation, for my CAD model it would be better to use Hexes rather than Tets, but I feel I have still no solid basis to state this, so, as I'm really new to this, I was wondering if any of you could recommend me any beginners literature on the pros and cons of Hexes and Tets and/or a guide to understand in which cases it is best to use hexes or tets or how to come up with an accurate solution to this problem.

Thanks in advance for any of your helpful replies.