[snappyHexMesh] How to add layers on the whole geometry surface

meithid · November 16, 2016, 16:10

Hi FOAMERS,

I find I can't add the layers on the whole geometry surface. In some region, the surface is not extruded for layers insertion.

In the first figure, the geometry surface is a bare cylinder. SHM can add the layers all over the surface successfully. In the second figure, SHM failed to add the layers in some corner regions. I try to tune FeatureAngle to some big value (300 degrees), but it didn't help.

Is there any way to do that the layers can be added for the second geometry surface.

MANY THANKS.

Attesz · January 24, 2017, 05:41

Hi meithid, did you solve this issue?

January 24, 2017, 05:41		#2
Attesz Senior Member Attesz Join Date: Mar 2009 Location: Munich Posts: 368 Rep Power: 17	Hi meithid, did you solve this issue? __________________ I am doing CFD Consulting Services. Ich biete CFD Strömungssimulationen an.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface	Kryo	OpenFOAM Meshing & Mesh Conversion	13	February 17, 2022 07:34
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
[PyFoam] and paraview	eelcovv	OpenFOAM Community Contributions	28	May 30, 2016 09:23
[snappyHexMesh] Layers in snappy collapse in some places of my solid	Yuby	OpenFOAM Meshing & Mesh Conversion	0	March 8, 2015 15:44
Cluster ID's not contiguous in compute-nodes domain. ???	Shogan	FLUENT	1	May 28, 2014 15:03