|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Nov 2009
Posts: 15
Rep Power: 13 ![]() |
Hi and a good morning everyone,
I have a beginners question: I've done a few simulations using bouyantPisoFoam. We are dealing with a building entrance and the flow that occurs if the door is opened. Up to now, I have simply used separate initial conditions for inner and outer volume - so in fact opened a sliding door at t=0. We would like to do a more detailed analysis and therefore are wondering whether its possible to include a moving door in the simulation so that say the door slowly opens at t=0 and is fully opened at t=3s. From what I gathered a moving mesh is not what I am looking for but rather a moving element within an existing mesh. We would really appreciate further information on this, Many thanks, Chris (Passive House Institute, Germany) |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 06:15 |
Time dependant pressure boundary condition | yosuke1984 | OpenFOAM Verification & Validation | 3 | May 6, 2015 07:16 |
[snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 12:27 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |